Open Network and Sharing Center from your Windows 7/8/10, etc and you will find the two new VMware Network Adapters. We can see here are the two new Virtual Networks. We will follow Step2 again and create the 2nd Virtual Network VMnet3, assign the subnet 33.33.33.0/24 and also change the DHCP Settings. To set the specific range of IP for the host click on DHCP Settings and specify the range of IP. If we want to assign IP address automatically to our hosts (PCs or VMs or Servers), we can use the DHCP service which is the part of this Virtual Network. You can see that a new Virtual Network has appeared VMnet2 in the Virtual Network Editor and it has a default subnet, e.g., 192.168.228.0 with subnet mask 255.255.255.0. But we will not use the given subnet, instead we will change it to 200.200.200.0/24. Click on Add Network and select the VMnet ( VMnet2) from the drop down list and click on OK. Then click on Change Settings first, so as to allow us creation of Virtual Networks. Start your VMware workstation software and open the Virtual Network Editor through Edit menu of VMware. We will achieve the fully working topology as shown above, by following the steps in this Visual Guide created by: Meena, Sr. For that we need, two routers (ISP-India, ISP-US), two hosts (, Client), and two Virtual Networks: We will create and configure the above topology. The idea is to provide the helping tool to candidates aspiring to practice and obtain their CCIE, CCNP, CCNA certifications. Two approaches of this integration has been elaborated & presented in this visual guide. Part#1 : II.The ultimate guide to understand the nuances of integrating GNS3 with VMWare WorkStation version 10/11/12. Of course, it will be necessary to test our final connectivity that the virtual machine (s) to put in our GNS3 virtual network have at least one network interface in the network card that we will assign to GNS3, here the VMware-NAT network card - VMnet8, as following:Ĭonfiguring the network card of a VM Workstation in NAT Restarting the Workstation Network Service We will then go to "DHCP Settings" and configure our new network:Ĭonfiguring the DHCP portion of the Workstation virtual network adapterįinally, we will set in "NAT Settings" the IP of the network gateway for our virtual environment (do not set ".1" as IP, it is the IP that your Windows host will have in this network!) :Ĭhanging the gateway IP for the virtual network Finally, we can validate by clicking on "Apply" We start by changing the IP of the network and mask it if necessary in "Subnet IP": To show that we can perform this integration with both an existing map and a new map, we will change the network address of this VMnet8 - NAT, we will see all the fields to think about. We start by going in "Edit", then in "Virtual Network Editor" and finally we will select "NAT" which is therefore associated with "VMnet8":Īccessing the VMware Workstation Network Configuration We can then move to the Workstation side configuration which is as simple. Overview of the GNS3 and VMware Workstation Integration Here i will give you the 2nd part of all the steps to integrate Vmware Workstation in GNS3 successfully.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |